Where to Use Nuts and Bolts for a Lord & Burnham Greenhouse

Where to Use Nuts and Bolts

Fastener Type	Use To Fasten
1" #8 rh wood screw	closures to blocking lean-to "7" gables
1" #10 rh wood screw	ridge end closure 1365 (L & R) LT "7"
1" #12 rh wood screw	purlin angle fitting to blocking "7" gables
1 1/2" #12 rh wood screw	angle fitting at lean-to-roof and gable, bar, ridge, ridge splice, closure to blocking, bar to scribing all models
3/8" #6 rh self-tapping screw type A	door sweep to door bottom
3/8" #6 rh self-tapping screw type Z	door check fitting to sill, eave, ridge to bar and buck casting to sill
1/2" #8 rh self-tapping screw type Z	barcaps to bar
1/2" #10 rh self-tapping screw type Z	angle fitting to sill, eave, ridge to bar and buck casting to sill
5/8" #10 rh self-tapping screw type Z	angle fitting to header
3/4" #10 rh self-tapping screw type Z	sash junction closure to ridge at partition and break in sash run
3/4" #14 rh self-tapping screw type Z	angle fitting partiation sill, flat brace to sill (g to g models)
7/8" #12 rh self-tapping screw type A	angle fitting to masonry at door bucks
1/2" #10 fh self-tapping screw type Z	hinge to buck and door
1/4 .20 X 3/8 rh mach. sc. w/nut	splice at header, eave-angle fitting at eave end
1/4 .20 X 5/8 rh mach. sc. w/nut	angle fitting at sill, buck spreader, deck bar, g to g gable corner splice at bottom rail ridge, shafting and header end
1/4 .20 X 3/4 rh mach. sc. w/nut	rafter splice, sill corner casting, sash, muntin
1/4 .20 X 1" rh mach. sc. w/nut	bar splice, sash muntin at splice
1/4 .20 X 2" rh mach. sc. w/nut	buck to bar at side entrance
24 X 1/2" #10 hex. hd. mach. bolt w/nut, aluminum	sash bearer fitting to bottom rail
1/4" X 3/4" hex. hd. mach. bolt w/nut, aluminum	vent rod to sash bearer
1/4 X 1" hex. hd. mach. bolt w/nut, lock washer. galv.	motor bracket z fitting to bar
1/4 X 1 1/2" hex. hd. mach. bolt w/nut, lock washer. galv.	vent shafting coupling
1/4" X 1 1/8" shoulder bolt w/nut and lock washer. galv.	vent sash arm and rod assembly
1/4" X 5/8" T-bolt w/nut and lock washer. galv.	angle fitting at buck closure - lock strike buck to sill fitting
1/4" X 7/8" T-bolt w/nut and lock washer. galv.	buck and bar to gable rafter, angle purlin to buck and bar. angle post to g to g. extension bar
1/4 .20 X 3/8 fh. mach. sc. w/nut aluminum	splice at vent top rail
1/4" X 1" carr. bolt w/nut and lock washer, galv.	motor bracket to z fitting
#9039 rawl plug	angle fitting at buck closer to masonry